Re: Information on putting a floor in my 16ft jon boat(aluminum)

Posted byTodd (216.175.73.95) on February 24, 2002 at 19:50:37:

In Reply to:Information on putting a floor in my 16ft jon boat(aluminum) posted by Larry Vancil on February 21, 2002 at 21:00:34:

I have the a Lowe 14'. I placed a 6" long and 2" wide peice of wood (it was a rectangle wood spike) next to the rib on the floor (long part against the rib). I then drilled a hole through the rib, parallel to the floor. I then put a screw through this hole and screwed it into the wood. Two screws in each peice of wood and a piece of wood in each corner. I then had something that I could screw the flooring into, yet remove if needed. The channels in the bottom flooring of the boat still allowed for water to drain. I can also still use a leaf blower or car wash sprayer to remove debris.

	The Ez-Coil Spring Rewinding Tool